Relay 5v 2 Channel 10A 250V แบบ Active High/Low

Relay 5v 2 Channel 10A 250V แบบ Active High/Low สามารถเลือกให้ทำงานได้ทั้ง Active HIGH / Active LOW เพียงแค่เซ็ตจัมเปอร์ที่ตัวบอร์ดเลือก High/Low

Description:

1) the module uses the original loose music relay normally open interfaces Maximum load: AC 250V / 10A DC 30V /. 10A
2) using the original Toshiba SMD optocoupler isolation driving ability stable performance; trigger current 5mA
3) Operating voltage 5V
4) the power indicator (green) relay status indicator (red) 7 the power indicator light (green) the relay status indicator (red) 7 the module can be set by the jumper high or low level trigger
5) fault-tolerant design even if the control line break the relay will not move;
6) the module size: 50mm * 41mm * 18.5mm (length * width * height)
7) with four fixed bolt holes holes 3.1 the interface design is user-friendly all interfaces can be directly connected through the terminal leads very convenient
8) Mm spacing 44.5mm * 35.5mm

Interfaces:

1) DC +: then the power supply positive (voltage according to the relay requirements 5V)
2) DC-: then the power supply negative
3) IN1: 1 signal trigger side you can set the high or low level control relay pull
4) IN2: Trigger side you can set the high or low level control relay pull

Relay output:

1) NO1: 1-way relay normally open interface the relay before the pull-off after the connection with COM1 short
2) COM1: 1 relay common interface
3) NC1: 1 relay normally closed interface the relay before the convergence with COM1 short pull after the floating
4) NO2: 2 relay normally open interface the relay before the suspension after absorbed and COM2 shorted
5) COM2: 2 relay common interface
6) NC2: 2-way normally closed relay interfaces relay before and COM2 short after the pull-vacant