มาใหม่เดี่ยวนี้ ANCEL BM310 & BM410 12V/24V Car Battery Tester Digital Car Battery Analyzer Battery Health Analyzer Car Battery Checker Battery Detector Automotive Battery Monitor Auto Battery Load Analyzer Alternator Tester Obd2 Scanner Car Diagnostic Tool Scanner ส่วนลดวันนี้

You may wonder if the battery needs to be replaced or just needs recharging. BM410 car battery load tester tells you the battery health by battery test and loading test. Also this battery analyzer can check alternator status. Save your trip and money.



☑️ THE TOP REASONS TO CHOOSE BM410:

● Alternator state check.
● Battery state check.
● Battery overload display.
● Fit for car motorcycle etc.
● Two testing clips for safe and easy operation.
● Free batteries heavy duty insulated clamps.
● Easy and safe to use no sparking.
● Small size light weight convenient to carry.
● Battery mate: for 12v & 24v car battery health condition checking with leds display indicates condition.
● Alternator check: accelerate your engine to 2000 rpm when the green light is lit charging circuit is ok.
● Pure copper wire and clip good conductivity accuracy reaches 0.1V high sensitivity.
● Reverse protection function-misoperation will not lead to burnout of the product the same product on the market does not have this.



☑️ THE MAIN FUNCTIONS OF BM410:

● Checking charge level.
● Functional test of dymano.
● Checking battery starting capability.
● Battery overload display.









☑️ ANCEL BM410 12V/24V BATTERY TESTER:

For checking and testing the battery capacity battery load capacity and the dynamo.

● Connection

Attach the cabla clip of the red cable to the positive(+) of the battery and the black to the negative (-).

● Checking The Dybamo

Connect the testing device. Start the engine and switch off the headlights radio etc. Star the engine again and switch on the headlights radio etc. In both cases then green signal LED GOOD should shine. The red signal LEDDefectivewill start to shine if the dynamo in bad condition. If the situation happen please go to local car workshop asap.

● Checking The Charging Level

Switch on the headlights for 1-2 minutes then switch off. Remove the cable clips from the battery wait approx.10 mins then switch the testing device on again. A signal LED will shine according to the charging status of the battery indicating Full Half-full or Very low charge.

● Battery Start Capability

The battery needs to be charged up to the maximum. Remove the connection of the ignition coil then connect the testing device. Try to start the vehicle using the key in the ignition switch. The engine cannot start (interrupted ignition). When the green signal LED Battery OK starts to shine the charging status of the battery is ok.

● Start The Battery Capability Load

Switch to the loading test mode then start the engine.

Full: six-five LED will be shine
Middle: four-three LED will be shine
Low: two-one LED will be shine if no LED shine it means the battery capacity is very low please charging the battery or change the battery



☑️ THE DIFFERENCE BETWEEN BM310 & BM410:

● BM310 only supports 12V battery testing.
● BM410 support 12V & 24V battery testing.





☑️ ANCEL BM310 & BM410 PACKING LIST: